SPR JUNIOR BANDSAW

SPECIFICATIONS

 

        
   
MOTOR:

1.5 kw standard, 415v, 3ph, 50hz, cabinet enclosed, foot mounted, grease pre-packed ball bearings

Optional: 0.75 kw  240v

ELECTRICAL CONTROLS:

24v switching control

3 switches - 1 push to start,

1 push to stop and  

1 emergency latch-in stop button    

Drive:

Twin “V” belt drive reduction on 1.5 kw

415v motor with a standard speed of 3000 ft/min

Optional 0.75 kw 240v motor with single “V” belt drive reduction

Optional speeds available on request

SAW BLADE:

13mm wide x 2870 x 3TPI

BLADE TENSIONER:

Fully automatic with blade tension maintained at all times

Entire motor and transmission and lower pulley assembly is slide tension mounted

Automatic blade tension lever mounted below left of table

Broad blade length adjustment not required

BLADE GUIDES AND CLEANERS:

Top and bottom guides are interchangeable

Blade guide is tin plated steel with built in tungsten carbide blade back up

Top and bottom guides are removable for cleaning

Guides and blade cleaners are easily removed with the use of a small ring spanner

WHEELS:

Light weight aluminium wheels - corrosion resistant

Top wheel easily removed for cleaning, dynamically balanced for vibration free operation

Automatic blade tensioning ensures true running of the blade at all times

Top wheel safety lock minimises likelihood of wheel becoming dislodged from its supports in case of blade breakage

CAPAITY:

Cutting clearance 275mm high x 305mm wide

STATIONARY CUTTING TABLE:

One piece 590mm x 810mm heavy duty 2.0mm stainless steel

Turned down edges for rigidity, fully supported for heavy duty use

Easy cleaning one-piece table, heavy-duty nylon table insert promotes longer blade life

GAUGE PLATE:

Large 406 x 152mm gauge plate mounted on full stainless steel assembly

Easy adjustment ensures uniform thickness of cut

Easily removed for breakdown work and cleaning

CONSTRUCTION:

Full stainless steel, smooth grain finish Removable stainless steel top and bottom doorsStainless steel back cover

SAFETY FEATURES:

Upper and lower pulleys (wheels) are completely enclosed but readily accessible

Blade is guarded above and below the cutting zone, wrap around top blade guard

Fail to safe door interlocks to Australian standard AS4024.1 ensure the machine will not operate with the doors in the open position

Machine ceases operation within approximately 5 seconds of power being turned off

Waist high, front of table mounted, start and stop buttons

Plus latch in, twist to release, emergency stop switch (in emergency operator can lean against the machine to cease operation. Button must be manually released to re-start machine

24 volt switching controlAdjustable polyurethane feet for maximum stability

Auto overload motor protection on 415 volt, manual on 240 volt

SANITATION:

Smooth grain finish and radius corners, together with removable doors, promotes ease of cleaning

Plastic removable bone dust tray

Sealed motor compartment eliminates scrap entry

WEIGHT:

Nett shipping weight:  160 kg                 SHIPPING SIZE in cm:   186 h x 92 w x 78 d

DIMENSIONS:

Height:                       1725mm               Floor area:                  670mm x 860mm

 

 

APPROVAL CERTIFICATES

Meets all current Work Cover and Australian Standards

Australian Communication Authority no. N3940

(“C” tick compliance labelling)

 

Mechanical Hazard Assessment

(Independent assessment to AS4024.1)

 

Department of Energy Certificate no. 6673

(Suitable for connection to Australian electricity supply)